CE Approved Decanter Centrifuge Separators 720mm Self Clean Orange Juice

One motor drive, this is a very simple design and are therefore cheap to purchase and operate. One motor drive are used when the solids volume is constant, the solids are easy to convey and the requirements regarding the residual water content of the solids are not very stringent, in other words, bowl and differential speed regulating facilities are not necessary. The input shaft of the drive is set in motion by the main motor via a second belt drive. This generates the
differential speed as a function of bowl speed and gear transmission. This can be easily changed by replacing the belt pulleys.

Two motor drive, it enable the differential speed to be regulated cost-effectively under good operating conditions; wide regulating ranges are possible. The secondary motor sets the input shaft of the gear in motion and generates the differential speed as a function of bowl speed and gear transmission. The differential speed can easily be regulated
by changing the motor speed. Two motor drive are used whenever solid volumes fluctuate significantly, when solids are conveyed under difficult conditions and when particularly stringent requirements are applicable with regard to residual water content.

Hydro drive, it works in a way which is similar to that of the two motor drive. The
difference is to be seen in the design.Instead of the mechanical gear, a rotating hydromotor is installed; this is supplied with
hydraulic regulation by a pump unit. Because the differential speed is proportionate to the conveyed quantity of oil, automatic
regulation can be provided without any problem.